Descriptions of All Parts & Accessories offered by Accuracy Speaks Inc.


Please note: Items that are numbered below match images that are provided on this page - if you require any clarification, please contact us.


Prices are subject to change without prior notice!


Service Rifle Accessories:

1. Service Rifle Tube: Stainless steel construction, fits under factory handguards to free float barrel and improve accuracy.

2. Barrel Nut Wrench: Used to install free floating handguards of all manufacturers. Closed design spreads torque to the whole nut and prevents breaking.

3. 1/2 X 1/4 Minute Rear Sight Base: Allows 1/2 or 1/4 minute elevation clicks. Oversize fitting pads eliminate sight twist.

6. .50 Front Sight: Provides the same sight picture as M-14NM blade.

7. .55 Front Sight: Provides the same sight picture as M-14 blade.

8. Single Stage Trigger Kit: Crisp 3 - 4 1/5 trigger pull, some fitting required, complete instructions included. Note: Please specify large or small pin (next to order quantity).



Match Rifle Accessories

1. Aluminum 2: Piece Handguard with Handstop, Hand filling design with adjustable round handstop and bipod stud.

2. Barrel Nut Wrench: Used to install free floating handguards of all manufacturers. Closed design spreads torque to the whole nut and prevents breaking.

7. Single Stage Trigger Kit: Crisp 3 to 4 1/5 lb trigger pull, some fitting required, complete instructions included.

8. Extended Scope Rail: Weaver Style Rail allows rear sight bases or high magnification scopes to be mounted forward for prone shooting, Gunsmith installation required.

10. Scope Rail Extender: Clamps over factory Flattop Receivers to raise and extend the scope base. Accepts Weaver rings. New Products 2-piece. New Design 2007




AR-15 Accessories:

1. Carbine Tubes: Service Rifle Style fits under factory Handguards.

2. Aluminum 2-piece Style replaces factory handguards and comes with bipod stud. (Not shown)




Other Accessories: 

1. M-14 Gas Cylinder Wrench: Supports Gas Cylinder when removing/installing plug, includes piston holding fixture for cleaning piston.

2. M-14 Piston Drills: Removes carbon build-up in piston and gas cylinder plug.

3. 10-22 Scope Rail: Attaches to receiver, barrel or both to provide additional rigidity. Accepts all Weaver Style Rings. Drilling and tapping required for barrel installation. Supplied with screws.

7. M1/M1A Scope Rail: Will fit either M1 Garand or M1A, replaces rear sight and firmly attaches to barrel. Requires drilling and tapping barrel and removal/mod of handguard. M1 rifles will require use of SLED as scope is mounted over receiver. $125

8. Shooting The Wilson Matches Manual: Training manual for shooting the Wilson matches. Includes photographs and complete instructions. For Nat'l Guard shooters. (Not shown)